KOBRA 16MINI

In order to simplify the cabinet construction as far as possible, we have done without the chamfers shown in the photo. If you prefer to include the all-round front chamfer, you will need the following information: 
Angle: 30° 
Width: 10 mm 
The cabinet consists of boards stuck together (butt jointed), making construction a simple matter. First of all, the individual boards are cut to size (refer to cutting list), stuck together (butt jointed) as shown in the drawing and firmly clamped for the duration of the drying time using parcel tape. Once the cabinet has been completely built, the cut-outs are made for the speakers, bass tube and terminals using a jig-saw. The last job is the surface treatment, i.e. painting, veneering or adhesive film. 

Inner damping

The damping of the speaker uses two mats of damping material pushed into the cabinet through the bass cut-out. To this end, the mats are folded once longways and once cross-ways and pushed into the cabinet in such a way that the space behind the bass tube remains free and the rest of the space inside the cabinet is loosely filled. 

Component parts list for 1 box
Tweeter:	MOREL MDT29	1 piece
Bass-midrange driver:	W 170 S 8 Ohm BEST BASS OR MOREL MW162 BEST MIDDL	1 piece
Crossover:
Bass reflex tube:BR 6.8	VISATON-6,5CM MOREL-2,5CM	2 pieces
Damping material:		1 bag
Wood screws:	3,5 x 19 mm	3 pieces
	3,5 x 25 mm	9 pieces
		................

Cabinet parts list for 1 box
Parts	Size (mm)	Quantity
Material: 19 mm chipboard or MDF
Front and rear panel	342 x 192	2
Side panel	380 x 230	2
Top and bottom panel	230 x 192	2